![]() Watch for system stability and proceed only gradually.This menu is used for setting the system interfaces. You can test the individual options out here for improving performance. Under this option, you can customize the frame buffer. With this option, enable or disable the VGA controller integrated into the chip. The aperture size is a virtual size and requires the specified memory, not all the time but only if required by the graphics card. The larger the value the faster can represented in the main memory paged out textures. AGP memory access (host cycles) will be passed without delay, if they fall within the reserved area. Here is for AGP (accelerated graphic port)-graphics cards in the RAM reserved a Speicheradressfenster, in which the memory accesses will be redirected. ![]() Only if an older card problems, turn this option off. To achieve full compatibility with PCI 1.2, you should have turned on this option. Here is the 32-bit write buffer that acts as a kind of cache by PCI transfers, enabled/disabled. If you are using any ISA cards you should have this option disabled, your card unless otherwise requires. However you can no longer use the memory above 15 MB. Install ISA cards with a framebuffer, here to run if the option enabled. This option should be under Win.x and DOS to enabled, otherwise disabled should be set. You have this option enabled, you must enable at the same time also the option video BIOS shadow. Should remember, though, that the caching brings risks, if the code is in the cache and want to write a program in the BIOS section. If you have this option enabled, the cache can consider BIOS of the graphics card to the address C0000h with the VIDEO to C7FFFh. Under Windows 95/98 does not so much brings this option. When the existing BIOS ROM is taken into account through the cache and this brings more performance, but almost only under DOS and Win3.x. We recommend the settings on car Max 266 to leave. This also used the parameters to Graphicspeicher and core. This function adjusts the speed of the FSB. If your memory is an ECC memory, then choose the option ECC. Settings: Non-ECC (should be correct for most of you) and ECC. You define here a less than optimal parity check, which only detects errors, but not eliminated. ![]() This option is strongly related to option of test of ECC (error checking and correction). Should be the default setting, so that no memory errors occur. Four strokes suffice in all cases, three bars are indeed faster, but not sufficient at all SIMMs. The value specifies how much time between two memory accesses. This option controls the latency between the active DRAM command and the read/write command. Specify the amount of time in which a storage line (row) is kept open before a Precharge. Under this option, the latency between the DRAM read command and is time, to which the data are actually available, set. This critical parameter info become in the EEPROM memory type, size, speed, voltage interface and module banks saved. Be configured the options from the default 'By SPD', by the contents of the SPD (serial presence detect) device is selected. ![]() ![]() Under this submenu you can set the optimal timing for options a, depending on the storage engine used by them. ↑ ↓ → ← :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:Helpį5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults DRAM Timing Selectable This should be, done carefully there settings here the stability of the overall system affect can. In this menu, settings can be made to the functions of the store. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |